Z-BLOK称重模块_美国BLH

描述

Z-BLOK称重模块专为满足库存和过程称重应用的要求而设计。无支撑设计（无支撑或检查杆），薄型和均匀的螺栓间距简化了在新船或现有船上的安装。整体式扩展组件，双悬臂设计和温度补偿全桥传感器，可最大限度地降低温度影响，从而可在室内或室外进行精确测量，几乎适用于任何环境。当地震或风阻是结构设计要求时，ANSI / ASCE认证设计提供了作为传感器的性能与作为结构构件的强度之间的有效平衡。由混合器扭矩，振动或其他外力引起的高达100％满量程容量的侧载实际上对重量测量没有影响。一体式电缆导管配件，密封式应变计和不锈钢传感器确保在潮湿或冲洗位置的长寿命。高过载能力，球墨铸铁安装硬件和高强度装配螺栓使Z-BLOK能够在其他失效的地方生存。

FEATURES

• Capacity range: 500, 1K, 2K, 5K, 10K, 20K, and 50K lb(227, 454, 907, 2.27K, 4.5K, 9K, and 22.7K kg)
• Checkless’ design—no stay or check rods required
• Low proile and integral thermal expansion assemblysimpliies installation
• Designed to meet ANSI/ASCE wind load and seismicrequirements
• Double cantilever design improves system performanceand accuracy
• FM and CSA approved

APPLICATIONS

•  Inventory silos
• Storage tanks
•  Process vessels

DESCRIPTION

Z-BLOK Weigh Modules are speciically designed to meet the requirements of inventory and process weighing applications. Checkless design (no stay or check rods),low proile, and uniform bolt spacing simplify installation

on new or existing vessels. The integral expansion assembly, double cantilever design, and temperature

compensated full bridge transducer, minimize temperature effects allowing accurate measurement indoors or out, in

virtually any environment. The ANSI/ASCE qualiied design provides an eficient balance between performance as a transducer and strength as a structural member when earthquakes or wind resistance is a structural design requirement.

Z-BLOK的独特设计融入了一个整体带有固定螺栓的膨胀/固定板总成。这种安装方式提供了简单的无校验安装时，允许较小的安装表面不规则和船舶/结构膨胀和收缩。球形负载按钮和插座消除载荷元件的扭转应力由不平整或不垂直的安装引起的表面。端部载荷应力，由容器/结构引起膨胀和收缩或过程振动由telon浸渍滑板否定。的膨胀/固位板总成附在其上模块在工厂，不需要调整。连接模块和模块的高强度螺栓扩展/固位板总成提供电阻提升力，完成无校验设计。